ChamboTW

Spark plug is brand new. I've now sorted the problem I had split the intake manifold when putting the carb back on, so it was just sucking air in and no petrol, I've super duper glued the split and she now runs like a dream, new manifold should arrive early next week fingers crossed I don't split this one

yeterday i replaced the cylinder and cylinder head gaskets following the workshop manual all went well and every thing went back together fine. started her up and she ran on half choke fine until warm then sat on tick over for about 4-5mins with no problems at all so i turned her off and put the side panels back on. tried starting her again but she would only start on full choke and then splutter to a stop checked all ground cables are secure, got plenty of fuel, got a spark, airbox and tubes are clean and clear. tried to start her again this morning and she wont start at all not even on full choke. any help or suggestions would be appreciated.

i rang my local dealer and if anyone else is interested the torque settings for the bolts on the front disc are 13 Nm.

i do apologise, i'm not really an internet forum user. i will take into account what you have said and put it into practice in the future.

i was recently involved in an accident and in the process i bent my front disc, i have brought a new one but unsure of the torque settings for it and i cant find them anywhere. does it really matter ? or can i just put it on and tighten it up?