JORDAN-432
Free-
Posts
30 -
Joined
-
Last visited
Previous Fields
-
Current Bike(s)
typhoon 172 DT soon
Profile Information
-
Gender
Male
-
Location
Bromley
JORDAN-432's Achievements
Newbie (1/14)
0
Reputation
-
the grips lol
-
LOL
-
whats the standard needle poisition for my dt125r 2000
-
is it ok just to buy the rings or should i get the whole piston kit? Nothing is damages just would like to put new rings in
-
no didnt go that far, i was going to split it as i thought there was a problem with my gears were inside the gearbox but it turned out to be the gear selector shaft.
-
well when i rev it over about 3k it vibrates quite bad. An unbalanced clutch is when the plates inbetween the friction plates aren't balanced because a bit of the plate has been taken off so you have to put them in evenly. I put them in as evenly as possible but just not sure whats wrong with it and thought this could be it.
-
i recently had my engine out because the gears weren't right so i sorted that, now i think that the clutch is unbalanced. can anyone tell me the symtoms of an unbalanced cluth please.
-
i dont no where i disconnected them from , i thought it would say it in the haynes but i guess not.
-
hi, ive just put my engine back in and theres 3 black pipes coming from the carb can u tell me which one goes to where. Thanks.
-
would i have to split the engine get to this
-
When i go into first or am going down gears when i push the gear lever it dosnt spring back up so i have to pust it up with my foot. anyone one whats going?
-
to much air of maybe an air leak if the chock has to be on all the time?
-
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=200466051141&ssPageName=STRK:MEWNX:IT There you go
-
Does any one no the width of the standard manifold.