hi all newbie to your site.
i bought a dtr that neede some tlc. after lots of blood sweat and tears its nearly finished.
problem is when i first rebuilt it it would'nt rev past 6000rpm when it was under load, 7000rpm when standing . the mains jet was 125 so i went up to a 140, this improved the reving by 1000rpm .then i went up to a 200 this improved the reving by a ferther 3000rpm . still the thing wont run right , low down in the rev range i get a deep sounding poping from the air box. high up in the rev range it will rev to 9/10000rpm then dies for a second or 2 , pops and bangs then comes back to life upto 9/10000rpm then does the same again.
the bike is H reg with fixed valve , full dep zorst and 1mm over bore.
never realy messed with fueling before on 2smokes so could do with a point in the right direction please.
thanks reevo